Printer setup checklist
One page to follow, or to hand to the person installing a printer.
A Star printer with CloudPRNT and an Epson printer with Server Direct Print are supported. See Supported printers for the models and for what has run on a device. The full steps are in Set up a Star printer and Set up an Epson printer.
Before the visit
- The printer model supports CloudPRNT (Star) or Server Direct Print (Epson). On Star mC-Print models use firmware 3.2 or newer.
- The printer was added by its paper width, and Tillcast reads its maker when it first connects. Or it was added with the right maker named: Star, or Epson. A named maker cannot be changed afterwards.
- The paper width is right, or the printer has the profile of its paper. A 58 mm printer needs a 58 mm profile.
- You have the printer URL for this exact printer. It is shown once.
- The venue network allows outgoing HTTPS (port 443) and DNS. No VPN, port forwarding or local server is needed.
- A computer on the same network as the printer.
At a Star printer
- Print the self-test page and note the IP address and firmware version.
- Open
http://<printer-ip>/and change the web admin password if it is still the factory default. - Enable CloudPRNT in HTTP mode.
- Paste the whole printer URL into the Server URL field. It starts with
https://. No trailing slash, no spaces. - Leave username and password empty.
- Set the polling time to 5 seconds.
- Leave MQTT off.
- Check the printer’s date and time.
- Save, then restart the printer.
At an Epson printer
- Open the printer’s Web Config at
http://<printer-ip>/and log in as administrator. - Check the printer’s date and time.
- Open TM-i Settings, then Server Direct Print, and enable it.
- Paste the whole printer URL into Server1, URL. No trailing slash, no spaces.
- Set Interval(s) to 5. Leave ID and Password empty.
- Set Server Authentication to Enable, and check that ePOS-Print reads Enable.
- Press Apply & Restart.
After the restart
- In the dashboard the printer’s status turns from Never connected to Online. Reload the page.
- A Star prints the welcome receipt. See First connection. An Epson prints none.
- An Epson added by its paper width: its page says Check the line width. Press Print calibration sheet and type the code under the longest ruler that stays on one line, or set its profile through the API. See Set up an Epson printer.
- The location and printer names on the receipt are the right ones.
- Press Test print on the printer’s page, or send a test job from your software.
- Keep the printer URL out of tickets, chat and source code.
If something fails, go to Troubleshooting.